The working principle of the ball head The tie rod with the ball head shell, the ball head of the steering spindle is placed in the ball head shell, the ball head is hinged with the shaft hole edge of the ball head shell through the ball head seat at the front end, and the ball head seat and the steering spindle are connected. The needle roller is embedded in the inner hole surface groove of the ball seat to control the direction of the guide wheel.
The ball joint refers to the mechanical structure that uses the ball connection to realize the power transmission of different axes. The universal joint is a very important part of the car. The combination of the universal joint and the drive shaft is called a universal joint transmission. On a vehicle with front-engine rear-wheel drive, the universal joint drive is installed between the transmission output shaft and the input shaft of the drive axle final reducer; while the vehicle with front-engine front-wheel drive omits the drive shaft, and the universal joint is installed Between the front axle half-shafts, which are responsible for both driving and steering, and the wheels.
We use cookies to offer you a better browsing experience, analyze site traffic and personalize content. By using this site, you agree to our use of cookies.
Privacy Policy
